Skip to content
Farbenhaft24 Raumgestaltung Farbenhaft24 Raumgestaltung

Material index for Wegberg

Floor laying in WegbergSix floors, properly ordered

Your satisfaction is our success

Anyone looking for a new floor in Wegberg usually arrives at the same question: which covering suits which room, and what does it ask of the subfloor? This page answers that in order. Six kinds of floor, each described against the same grid, so you can lay two of them side by side before you decide.

Six entries Fanned material sample cards showing different wood surfaces on a workbench
Sample cards side by side: wear layer, edge and colour can only be judged against one another.
In the index Six kinds of floor
Interior finishing since 2012
For Wegberg and the Heinsberg district
Section 01Index

The whole index at a glance

Every entry is described against the same three points: what the covering is, where it proves itself and what it asks of the subfloor. That way the decision is made by the room in question rather than by the best lit showroom.

Section 02The entries

Six floors read against one grid

The order is the order of the index and it does not change. Read from top to bottom you move from the hardest floor to the softest, and you can watch the quiet in the room increase while the demand on flatness rises.

M 01 Close view of a laid solid wood floor showing grain and the pattern of the joints
Material plate. It shows the type of floor covering, not a completed job.

Solid wood plank

The floor that outlives a move and can be made new again.

What it is

A plank cut from a single piece of timber, usually oak, ash or larch. It is nailed, screwed or fully bonded and then sanded, oiled or lacquered. Because the wood is the same all the way through, the surface can be taken back several times over its life.

Where it belongs

Living rooms, dining rooms, hallways and bedrooms in houses where the floor is meant to stay. Not in a bathroom, a laundry room or anywhere that is regularly washed down.

What the subfloor needs

The driest subfloor in the whole index. Solid wood moves with the humidity of the room, so it needs a generous expansion gap, a sound build up and a screed whose residual moisture was checked before laying.

M 02 Close view of a parquet floor laid in a basket weave pattern of pale wood blocks
Material plate. It shows the type of floor covering, not a completed job.

Engineered parquet

Real timber that behaves calmly, even over heating.

What it is

A real wood wear layer on a cross bonded core. The build up takes the strong movement out of the timber without changing the surface: what you see is still grown wood, with knots, checks and colour variation.

Where it belongs

Anywhere solid wood would be too thick. Above all over underfloor heating, because the lower build up lets the warmth through, and in flats where the door height is tight.

What the subfloor needs

A flat, clean and dry subfloor. Bonded it lies quieter and conducts heat better, floating it is finished sooner. Which of the two makes sense is decided by the room, not by the price.

M 03 Close view of a pale laminate floor with an even printed wood grain
Material plate. It shows the type of floor covering, not a completed job.

Laminate

Quick to lay, affordable, and honestly not real wood.

What it is

A wood based core board carrying a printed decor layer and an overlay that takes the wear. The picture on it is printed rather than grown, but the surface is very scratch resistant and comes in a great many decors.

Where it belongs

Bedrooms, children rooms, studies and side rooms. Wherever a floor should be renewed quickly and without much fuss, and may be swapped again in a few years.

What the subfloor needs

A flat, dry subfloor and an acoustic underlay, otherwise every step is heard in the room below. The expansion gap stays clear, behind the radiator as well, or the field lifts.

M 04 Close view of a grey stained design floor in a plank format
Material plate. It shows the type of floor covering, not a completed job.

Vinyl design flooring

The one entry that may also stay in a bathroom or kitchen.

What it is

A resilient covering in planks or tiles, with a wear layer over a printed decor. It comes as a bonded product and as a click system, on a mineral or a wood based core. It is waterproof, quiet and thin.

Where it belongs

Kitchen, hallway, bathroom, utility room, practice and shop floor. In living rooms too, when a pattern such as herringbone is wanted without the work of a real parquet.

What the subfloor needs

Very flat, because the covering is thin and traces every unevenness. It is usually skimmed and primed first. Bonded it works best over underfloor heating, because the warmth arrives directly.

M 05 Close view of a cork surface with its fine granulate structure
Material plate. It shows the type of floor covering, not a completed job.

Cork

The quietest warm floor, with a surface of its own.

What it is

Pressed bark of the cork oak, either as a finished element with a click joint or as a tile to be bonded. Cork gives slightly underfoot, feels warm and noticeably softens steps in the room. The surface is sealed or oiled.

Where it belongs

Children rooms, bedrooms, studies and rooms where you stand a lot. Not where water stands permanently, and over underfloor heating only after discussion, because cork insulates rather than conducts.

What the subfloor needs

Flat, dry and clean. Bonded, cork needs a skimmed subfloor, because every edge shows through. The seal decides how forgiving the floor turns out to be day to day.

M 06 Close view of a beige carpet with a patterned pile
Material plate. It shows the type of floor covering, not a completed job.

Carpet

Where quiet matters, nothing in the index beats it.

What it is

A textile covering as broadloom or as tiles, backed with felt, foam or bitumen. It is bonded, stretched or laid loose. Pile, density and backing decide how it looks, how long it lasts and how much sound it absorbs.

Where it belongs

Bedrooms, offices, stairs and any room where footsteps and voices are a nuisance. In commercial work often as tiles, because a single damaged patch can be swapped.

What the subfloor needs

Clean, dry and free of dust, because the adhesive has to hold. Small unevenness is forgiven, moisture from below is not. Old adhesive residue is removed first.

We look at the room and tell you which entries are worth considering at all.

Narrow the choice together
Section 03Compare

The same five questions, asked of all six

Five questions settle almost every choice in practice. Here are the answers for every entry side by side, without ranking and without a recommendation, because which floor is right depends on the room.

The table can be scrolled sideways.

The six entries of the index compared side by side
Entry Damp room Underfloor heating Footfall in the room Build up height Renewable later
M 01Solid wood plank No Only with care Medium High Sanded back repeatedly
M 02Engineered parquet No Well suited Medium Medium Once or twice
M 03Laminate No Suitable Hard, needs underlay Medium No, it is replaced
M 04Vinyl design flooring Yes Very well suited Quiet Low No, it is replaced
M 05Cork No Only with care Very quiet Medium Surface can be renewed
M 06Carpet No Suitable Quietest of all Low No, it is replaced

These answers describe the kind of floor, not one particular product. Within a kind there are versions that do more, such as laminate rated for damp rooms. What applies in your room we settle on site.

Section 04Subfloor

What every entry asks of the floor beneath it

No covering in the index is better than the build up it lies on. The visible floor is the last of several layers, and the four checks underneath decide whether a joint opens up two years later.

The build up from the bottom up

0504030201
01 Structural slab or screed Carries everything above it
02 Primer Binds dust and evens out absorbency
03 Levelling compound Brings the surface into plane
04 Insulation or acoustic layer According to covering and method
05 The chosen covering Bonded, floating or stretched

Four checks before the first board

01

Flatness

A straight edge run across the area. Whatever gives way here shows up in every joint later, with thin coverings within weeks.

02

Residual moisture

A screed still giving off moisture pushes timber and releases adhesive. So it is checked before laying and, in doubt, given more time.

03

Soundness and cleanliness

Loose layers, old adhesive and dust come off. An adhesive is only as good as what it is holding on to.

04

Heights at doors and junctions

Door leaves, thresholds to neighbouring rooms and junctions at heating and stairs are calculated beforehand, not solved afterwards.

We look at the existing build up, measure how level it is and tell you what still has to happen before anything is laid.

Have the subfloor checked
Section 05How it runs

From the enquiry to the handover

Five steps, in this order. You know from the start when a decision is needed from you and when the room should be cleared.

01

Enquiry

You describe the room, roughly how large it is, and what you have in mind. One sentence is enough to start.

02

Measuring on site

We measure, look at the existing build up and check door heights and junctions.

03

Choosing from the index

We narrow it to the entries that suit the room, and you see the samples in your own light.

04

Preparing the subfloor

Old covering out, skim, prime, let it dry. The invisible part, where everything is decided.

05

Laying and handing over

Laying, skirting, closing the junctions and clearing the site. You walk the room with us.

Section 06Completed

Floors that are already down

Photographs from our own jobs. The reference on each one points back to its entry in the index, so a picture can be matched to a kind of floor.

Living room in herringbone Design flooring, fully bonded
Hallway running into the living room One continuous field, no threshold
Wall junction and skirting Expansion gap and cutting in
Utility room with a coated floor Cellar area, pale and wipeable

B 01 stands for a coated utility floor. It is not an entry in the index, but it is part of what we carry out.

Section 07Enquiry

Which floor for your room in Wegberg?

Write one sentence about the room and the entry you are interested in. The answer comes from the person who will lay the floor.

Write an email
info@farbenhaft24.de
Address
Cäcilienweg 15
41836 Hückelhoven
When to reach us
Calls on weekdays, a call back in the evening as well.

If it needs to be quicker, call. A call back in the evening is possible too.

Section 08The firm

Who lays the floor

Tobias Knopczyk, owner of Farbenhaft24 Raumgestaltung
We treat your home as though it were our own

Owner, Farbenhaft24 Raumgestaltung

Tobias Knopczyk has run Farbenhaft24 Raumgestaltung from Hückelhoven since 2012. He learned the techniques from his father, who spent his working life in construction. Alongside floor coverings the firm carries out drywall, wallpapering, painting and plastering, which helps with a floor change: skirting, wall junction and making good all come from one hand.

One point of contact Measuring, subfloor and laying from one hand
Neighbouring trades Skirting, wall junction and making good without a second firm
Choosing with samples A decision in your own light rather than in a showroom

Wegberg and its neighbours

Wegberg sits in the Heinsberg district, and the district is our working area. A flat in the centre of Wegberg, a house in Beeck or in Rath-Anhoven is the same short drive.

  • Wegberg
  • Heinsberg
  • Hückelhoven
  • Erkelenz
  • Geilenkirchen
  • Wassenberg
  • Übach-Palenberg
  • Gangelt
  • Selfkant
  • Waldfeucht
Section 09Questions

What people usually ask before changing a floor

Answers to what comes up in almost every first conversation.

Not always. Tiles and firmly fixed coverings can serve as a subfloor if they are flat, dry and sound. Carpet, loose coverings and anything that springs underfoot comes out. What applies in your case is settled by the measuring visit.

Thin bonded coverings conduct best: vinyl design flooring and engineered parquet. Laminate and carpet also work when the build up is matched to it. Solid wood and cork insulate more strongly and are only used after discussion.

In this index the vinyl design flooring is the entry that tolerates splash water and frequent washing down. In a kitchen the junctions at the sink and the appliances matter as well, in a bathroom the perimeter seal.

That depends on the subfloor, not on the covering. If skimming and priming are needed, drying times come with them and they cannot be shortened. At the measuring visit we tell you what to expect before you put furniture into storage.

You can. It is worth going through the choice together first, so that wear layer, laying method and subfloor match. Buying the wrong build up saves on material and costs the difference in preparation.

Yes. What matters is that the owner has agreed and that it is clear whether the floor may stay when you move out. For footfall sound in apartment buildings there are build ups that bring that with them.